Testes mass in megachiropteran bats varies in accordance with sperm competition theory

Sperm competition is a widespread phenomenon influencing a range of characters, including investment in gonadal tissue. Conspecific proximity is one factor which can influence the risk of sperm competition and hence testicular investment, and decreased confidence of paternity may be one cost of group living. Aspects of female biology may also influence spermatogenic investment and sperm morphology. This study examines the associations between relative testes mass and roost-group size across 17 species of Megachiroptera. Associations between breeding season duration and investment in spermatogenesis are also examined, as are associations between female reproductive tract dimensions and testes mass and dimensions of spermatozoa across all bats. Relative testes mass was significantly positively associated with roost-group size at a species level and after appropriate phylogenetic control (pairwise comparisons and comparison of independent contrasts). There were no significant relationships between breeding season duration and relative testes mass. Across all bats, neither testes mass nor sperm length were significantly related to dimensions of the female tract. The results are discussed in the context of sperm competition. Received: 7 January 1998 / Accepted after revision: 8 August 1998     

Indoor and outdoor PM mass and number concentrations at schools in the Athens area

Simultaneous indoor and outdoor PM₁₀ and PM_2.5 concentration measurements were conducted in seven primary schools in the Athens area. Both gravimetric samplers and continuous monitors were used. Filters were subsequently analyzed for anion species. Moreover ultrafine particles number concentration was monitored continuously indoors and outdoors. Mean 8-hr PM₁₀ concentration was measured equal to 229 ± 182 μg/m³ indoors and 166 ± 133 μg/m³ outdoors. The respective PM_2.5 concentrations were 82 ± 56 μg/m³ indoors and 56 ± 26 μg/m³ outdoors. Ultrafine particles 8-h mean number concentration was measured equal to 24,000 ± 17,900 particles/cm³ indoors and 32,000 ± 14,200 particles/cm³ outdoors. PM₁₀ outdoor concentrations exhibited a greater spatial variability than the corresponding PM_2.5 ones. I/O ratios were close or above 1.00 for PM₁₀ and PM_2.5 and smaller than 1.00 for ultrafine particles. Very high I/O ratios were observed when intense activities took place. The initial results of the chemical analysis showed that accounts for the 6.6 ± 3.5% of the PM₁₀ and for the 3.1 ± 1.4%.The corresponding results for PM_2.5 are 12.0 ± 7.7% for and 3.1 ± 1.9% for . PM_2.5 indoor concentrations were highly correlated with outdoor ones and the regression line had the largest slope and a very low intercept, indicative of no indoor sources of fine particulate . The results of the statistical analysis of indoor and outdoor concentration data support the use of as a proper surrogate for indoor PM of outdoor origin.     

岩体开挖卸荷过程力学特性分析

基于岩体开挖卸荷过程中力学参数变化理论的分析研究,建立卸荷岩体有限元分析模型,运用ADINA有限元分析软件对岩体进行一维卸荷数值仿真研究。根据有限元数值分析计算成果得到岩体力学参数与主卸荷方向累计开挖卸荷量间的变化关系曲线。结果表明:岩体开挖卸荷过程中,岩体力学参数变形模量、泊松比、粘聚力和内摩擦角等呈现出随开挖卸荷量的变化而发生变化的特征,随卸荷量的增大有减小的趋势,但它们不是从初始值一直减小到零,而是随卸荷量的增大减小到一定的量值后,岩体的裂隙张开、结构面的扩展到一定的程度,岩体的力学参数保持一定的量级不再减小。     

细水雾中雾滴和高温环境的热质交换研究

由雾滴的表面的组分方程和能量方程入手,探讨雾滴在静止的高温环境中的热质交换及生存时间。应用折算薄膜理论,通过特征时间的比较,提出雾滴与高温环境主要通过沸腾机制实现热质交换;考虑滴径与速度变化的耦合作用,应用数值方法研究雾滴在强迫对流环境中与高温环境的热质交换情况。结果表明:对于滴径较小的雾滴不可能达到火焰区或可燃物表面实施火焰冷却和表面冷却,其灭火作用主要依赖于汽化吸热。     

基于岩体质量指标Q分类系统的风险分析方法

基于岩体质量指标Q分类系统,应用Monte-Carlo模拟技术,研究了岩体质量风险分析方法。该方法视Q分类系统中各单因素取值为随机变量,建立了各单因素取值概率模型;通过对所建模型的抽样计算,可获取所评价岩体实际Q值小于设计所采用Q值的概率;通过对比分析Q值累计曲线和岩体质量分布图,可得到任意Q值对应的风险概率,查清岩体中可能出现的质量等级以及每个质量等级所占百分比的情况。本文研究成果已在青岛胶州湾海底隧道工程中得到应用,并获得良好效果。     

确定岩体斜坡滑动面抗剪强度的动态反分析方法

滑动结构面的抗剪强度在岩体滑坡的稳定性计算中是最重要的参数,也是最难以确定的。基于岩体抗剪强度是多种因素影响下的随机变量这一认识前提下,本文以西柏坡“中共中央解放军总部”旧址滑坡为例提出了确定岩体斜坡滑动面抗剪强度的动态反分析方法,并对该方法获得的抗剪强度的实用性进行了分析。结果表明,反分析方法是获得岩体斜坡滑动面抗剪强度的最经济、合理的途径。     

液化四氟乙烷小孔泄漏试验研究

采用高速摄影技术,考察了液化四氟乙烷发生小孔泄漏时,其水平泄漏和垂直泄漏的初始云团演化行为、泄漏的质量流率、喷射速度和喷射角,并与理论计算公式进行了对比。结果表明:水平喷射两相云团尾部出现涡流,涡流大幅加快了云团向空气中扩散的速率;垂直喷射的两相云团在地面形成液池,液池大幅增加了液化气体向空气中蒸发的速率。水平泄漏试验的喷射角与容器内超压变化规律相似,泄放初期喷射角逐渐增大,经历一段平坦期,到泄放末期喷射角减小。水平泄漏和垂直泄漏的初始喷射速度分别为25 m/s和20 m/s,与理论值26.6 m/s基本吻合。水平泄漏的质量流率的试验值和理论值分别为0.0598 kg/s和0.0684 kg/s,垂直泄漏的分别为0.0472 kg/s和0.059 6 kg/s,结果对比基本吻合,推荐的泄漏质量流率和小孔喷射速度公式可以用于液化四氟乙烷小孔泄漏。     

Analysis of trace dicyandiamide in stream water using solid phase extraction and liquid chromatography UV spectrometry

An improved method for trace level quantification of dicyandiamide in stream water has been developed. This method includes sample pretreatment using solid phase extraction. The extraction procedure (including loading, washing, and eluting) used a flow rate of 1.0 mL/min, and dicyandiamide was eluted with 20 mL of a methanol/acetonitrile mixture (V/V = 2:3), followed by pre-concentration using nitrogen evaporation and analysis with high performance liquid chromatography–ultraviolet spectroscopy (HPLC–UV). Sample extraction was carried out using a Waters Sep-Pak AC-2 Cartridge (with activated carbon). Separation was achieved on a ZIC^®-Hydrophilic Interaction Liquid Chromatography (ZIC-HILIC) (50 mm × 2.1 mm, 3.5 μm) chromatography column and quantification was accomplished based on UV absorbance. A reliable linear relationship was obtained for the calibration curve using standard solutions (R² > 0.999). Recoveries for dicyandiamide ranged from 84.6% to 96.8%, and the relative standard deviations (RSDs, n = 3) were below 6.1% with a detection limit of 5.0 ng/mL for stream water samples.